Figure 1
5
How to Assemble Your Ceiling Fan
1.
Remove the hanger ball portion from the
downrod/hangerball assembly by loosening the set
screw in the hanger ball until the ball falls freely
down the downrod. Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 4
(Figure 1).
2.
Loosen the two set screws in the downrod support.
Route black, blue and white lead wires through the
downrod (Figure 2).
3.
Position downrod support and align the clevis pin
holes in both parts. Install the clevis pin and secure
with the hairpin clip. Tighten the two set screws
and locking nuts in the downrod support (Figure 3).
4.
Route wires through motor coupling cover, canopy
screw cover and canopy (Figure 4).
5.
Reinstall the hanger ball on the downrod as
follows.Route the three 80-inch wires through the
hanger ball. Position the pin through the two holes
in the downrod and align the hanger ball so the pin
is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin.
Securely tighten the set screw in the hanger ball.
A loose set screw could create fan wobble
(Figure 5).
PIN
SET SCREW
DOWNROD
HANGER BALL
DOWNROD
DOWNROD SUPPORT
HAIRPIN CLIP
SCREWDRIVER
SET SCREWS AND
LOCKING NUTS (2)
BLACK, BLUE &
WHITE LEADS
CANOPY
GROOVE
HANGER BALL
(ATTACHED TO
DOWNROD)
SET SCREW
PIN
Figure 5
Figure 3
BLACK, BLUE &
WHITE LEADS
CANOPY
CANOPY COVER
MOTOR COUPLING
COVER
Figure 4
BLACK, BLUE AND
WHITE LEADS
DOWNROD
SET SCREWS AND
LOCKING NUTS (2)
Figure 2
CLEVIS PIN
