Figure 1
Figure 2
Wire Harness
Housing
Support
Cover
P700008__
Housing
Control
Cover
P700050
Receiver
Control Unit
Antenna
Wire
Switch Detail
SW70 Remote Receiver Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
To Be Used With The Caruso
®
FP7000 Series Fan Assembly Only
Unit Weight 2.6 lbs (1.18 kg)
Applicable only to TR24 Hand-Held Remote or the C25 Wall Control
Be sure the electricity to the fan is turned off!
Check to see that all connections are tight. To avoid
possible electrical shock, make sure that the electrical
wires are completely inside the switch housing and
not pinched between the switch cap base and switch
housing.
WARNING
1. Removing the Housing Support Cover:
Remove the original housing support cover from the fan
by unscrewing the four screws and unplugging the wire
harness connector (Figures 1).
2. Setting the Receiver Code:
The remote unit has 16 different code combinations.
It may be necessary to test a couple frequency code
settings to improve signal reception and/or eliminate
interference from other remote control household items.
Multiple fans should have different code settings to allow
independent fan control. To set the code, slide code
switches to the same positions as is set on your TR24 or
C25 transmitter(s) (Switch Detail - Figure 2).
3. Installing the Remote Receiver Unit:
Connect the plug from the receiver unit into the socket
located in the fan assembly. Connect terminal from
antenna wire to terminal inside center housing support.
Slide housing control cover over the remote receiver unit
(Figure 2).
4. Installing the Housing Control Cover:
Slide the assembled housing cover over the housing
support base by installing and tightening the four screws
(Figure 2).
Copyright 2013 Fanimation, Inc.
2013/09
10983 Bennett Parkway
Zionsville, IN 46077
Toll Free (888) 567-2055 • FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website @ www.fanimation.com
NOTE: The illustrations shown is not to scale or its actual
confi guration(s) may vary.
