How to Set and Operate Your TR24 (Hand-held) or C25 (Wall) Remote Control
IMPORTANT NOTE: Be sure the code switches are set to
the same position as set on your remote receiver unit.
Setting TR24 Hand-held Remote Control:
1. Hand-held Transmitter:
Remove battery cover, press
firmly below arrow and slide battery cover off. Slide
code switches to the same positions as set on your
remote receiver (Figure 1). Replace battery cover on the
transmitter.
NOTE: In case of weak reception, replace battery inside
remote control.
Setting C25 Wall Remote Control:
1. Wall Transmitter:
Remove the cover plate. Slide code
switches to the same positions as set on your remote
receiver. Install the battery. Re-install the cover plate
(Figure 3).
NOTE: In case of weak reception, replace battery inside
wall control.
2. Installing Wireless Wall Transmitter
(Figure 4)
:
WARNING: Be Sure the Electricity is Turned
OFF
!
• Remove the existing wall plate and switch.
• Be sure to complete the electrical circuit within the
junction box by-passing wall control. Connect black to
black, white to white, green to green. Carefully push
wires into the outlet box.
•
Attach wall control unit to outlet box using the two 6-32
screws provided.
•
Attach wall plate to the switch control front using the two
small screws provided.
• Restore electrical powe
r.
Operating Hand-Held & Wall Controls:
1. Operating & Using Remote or Wall Transmitter
(Figure 2 & 3):
If not using the hand-held remote for long periods of time,
remove battery to prevent damage to transmitter. Store
the transmitter away from excess heat or humidit
y.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• OFF Push Button – fan o
ff
• Light Push Button – toggles on/o
ff and brightness
control for optional light arms
T
o control either light hold down key to increase or
decrease brightness. T
ap key quickly to turn light on or
off.
The light keys have auto resume and will stay at the
same brightness as the last time it was turned off.
Figure 1
Figure 2
LIG
HT
FAN OF
F
LOW
MED
HI
Figure 4
NOTE: Supply wires and fan wires
omitted for clarity.
LIGHT
FAN OFF
LOW
MED
HI
LIGHT
FAN OFF
LOW
+ AA Battery _
MED
HI
Wall Transmitter Unit Detail
(located on front of Wall Control
behind the cover plate)
Figure 3
3V, CR2032
BATTERY
2 PCS
Remote Transmitter
Unit Detail
1 2 3 4
ON ESE
