7
3.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
brown, blue, red, gray, yellow wires and safety cable
through the downrod. (Figure 3)
4.
Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten
the two previously removed set screws with locking
nuts in the downrod support. (Figure 4)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 2
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
How to Assemble Your Ceiling Fan
Hairpin Clip
Clevis Pin
Downrod
Set Screws and
Locking Nuts (2)
Set Screws and
Locking Nuts (2)
Hairpin Clip
Figure 3
Pin
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 6. (Figure 1)
Figure 1
Downrod
Hanger Ball
Set Screw
Figure 4
Brown, Blue, Red, Gray,
Yellow wires and Safety
Cable
Clevis Pin
