8
Mounting the Fan Blades
1.
Lay the blade holder on a flat surface with the inside
of the blade holder facing up. This is the side with the
threaded posts and pitched foot.
2.
Position the 3 threaded posts on the blade holder through
the 3 holes in the blade. Make sure the bottom edge of the
blade is fully seated against the blade holder.
3.
With a Philips screwdriver, fasten the blade with three
screws and lockwashers provided, do not over tighten.
(Figure 1)
4.
Attach the assembled blades to the bottom of the rubber
flywheel using the flywheel screws provided. (Figure 2)
Figure 1
Figure 2
Screw
(2 per blade holder)
Installing the Canopy Housing & Downrod Fabric Sleeve
1.
Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
NOTE:
The threaded rods in the hanger bracket serves as
guides for easier canopy installation.
2.
Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 1b).
3.
Carefully wrap the fabric sleeve (with Velcro) around the
downrod.
Figure 1a
Figure 1b
NOTE:
Supply wires and fan wires omitted for clarity.
NOTE:
This step is applicable
after
the neccessary wiring
is completed. (see pages 7)
▲
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
INSTALLATION NOTE
Attach the assembled Blades to the Rubber Flywheel
using the holes marked #4 for 4-blade application.
5.
Make sure the screws securing the blade holders to
the flywheel are tight and that the blade holders are
properly seated on the flywheel. (Figure 2)
4.
Cut off excess sleeve so that it rests on top of the motor
coupling cover and the top of the sleeve touches the
bottom of the hanger ball on the downrod.
Summary of Contents for Seaney's Voyage LB320BL
Page 15: ......
