15
How to Operate Your Ceiling Fan (Continued)
3V CR2032
Battery (2 pcs)
Figure 4
4.
To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
5.
If you have multiple fans and want to program all
fans to one handheld control. Slide the Dip Switch with
the same position in ALL receiver to ONE handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process. Each fan needs
to be no more than 30 feet from the handheld control
that you would like to program. Please note the wall
switch that controls the power to your fan(s) should be
in the off position until you are ready to program your
handheld remote(s).
6.
If you have multiple fans and want to program each
fan to separate handheld controls. Slide the Dip
Switch with the same position in both receiver and
handheld to set up the code for each fans and follow
Step 1 of the remote control speed set up process
below for each fans. Repeat these steps for each fan
that you would like to program to a separate handheld
remote. Please note that the wall switch that controls
the power to your fan(s) should be in the off position
until you are ready to program your handheld
remote(s).
7.
To set the remote code in the same positions as
the receiver, use a small screwdriver or ball point pen
(neither included) to slide dip switches firmly up or
down. (Figure 5)
NOTE:
Factory setting is all up. Do not use this
position.
NOTE:
The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
Remote
Control
Dip Switch
Figure 5
Summary of Contents for Kute FPD8534 Series
Page 51: ......
