15
How to Operate Your Ceiling Fan (Continued)
5.
To set the remote code same positions as the
receiver with a small screwdriver or ball point pen
(neither included), slide dip switches firmly up or
down. (Figure 5)
NOTE:
Factory setting is all up. Do not use this
position.
NOTE:
The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
6.
Replace battery cover on the remote control with
previously removed screw by screwdriver. (Figure 6)
Remote
Control
Dip Switch
Figure 5
Figure 6
Figure 7
7.
Remote functions: (Figure 7)
• Indicator LED light: fan speed and light dimmer
indicator
• button: Tap once to turn off the fan. Press and
hold this button for 5 seconds to turn on or turn off
the buzzer.
• Fan Speed:
Turn on fan and turn speed up.
Turn on fan and turn speed down.
• Light button: Turn ON\OFF the light.
Increase light output level.
Decrease light output level.
• Sleep Timer:
The fan and light will turn off after 1 hour.
The fan and light will turn off after 3 hours.
The fan and light will turn off after 6 hours.
• Home Away: Tap this button, the light will blink
twice signaling this feature is on; the fan will turn off
and the light will randomly turn on and off while you
are away. Pressing any button will cancel the feature.
3V CR2032
Battery (2 pcs)
Figure 4
4.
To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
