1.
Check to see that you have received the following parts:
NOTE:
If you are uncertain of part description, refer to
exploded view illustration.
This manual is designed to make it as easy as possible for you to assemble,
install, operate and maintain your ceiling fan
Tools Needed for Assembly
4
Installed Wire Length
Wire Size A.W.G.
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 11). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
WARNING
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
Up to 50 ft.
14
50-100 ft.
12
NOTE:
Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
• Motor Assembly
• Hanger Bracket Assembly
Light Plate Assembly
LED Kit
Glass
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Holder Set
• Blade Set
• Light Plate Assembly
• Glass
• LED Kit
• Light Wire Cap With Screw
• Hand-held Remote
• Receiver Unit
• Steel Cap Assembly
• Hardware bags:
–
Sixteen
3/16
˝
-24
Serrated Head
Screws
(blade to blade holder)
–
Sixteen Flat Washers
(blade to blade holder)
–
Eleven 1/4˝-20
Pan Head Screw
(blade holder to motor)
–
Four Wire Connectors
–
Balance Kit
–
Bag Assembly Safety Cable
Motor Assembly
Downrod/
Hanger Ball
Assembly
Hanger Bracket
Assembly
Ceiling Canopy
Motor Coupling Cover
Assembly
Canopy Screw Cover
Assembly
Hardware Bags
Hand-Held
Remote
Receiver Unit
Blade Holder Set
Blade Set
Steel Cap
Assembly
Light Wire Cap
With Screw
• One Phillips head screwdriver
(not supplied)
• One 1/4˝ flat head screwdriver
(not supplied)
• One stepladder
• One wire stripper
• One hex wrench
(not supplied)
