How to Assemble Your Fan Blades
(continued)
13
How to Assemble Your Light Kit or Cap
1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2.
Assemble the light plate assembly to the support
bracket using the two key slots in the light plate
assembly. Replace the previously removed screw and
securely tighten all three screws. (Figure 2)
3.
Remove the three screws in the light plate assembly
and retain the screws for later. (Figure 3)
2.
Secure the blade holders to the motor support using
the 1/4˝-20 screws through the holes located on the
side
of the motor support. (Figure 2)
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
Blade Holder
1/4˝-20 Screw
(2 per assembly)
Motor Assembly
Figure 2
HARDWARE USED:
x 10
1/4
˝-20
SCREWS
Figure 1
Figure 2
Figure 3
Light Plate
Assembly
Light Plate
Assembly
Motor Assembly
4. For use with light kit (A).
Connect the 2 pin connector from the LED kit
to the 2 pin connector from motor assembly.
(Figure 4)
Figure 4
LED Kit
Motor Assembly
