Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached to
the ceiling joist. Be sure the groove in the ball is lined up
with tab on the hanger bracket. (Figure 4)
5.
Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and firmly tighten screw (Figure 4). Cut
off excess safety cable.
of
4.
How to Hang Your Ceiling Fan (continued)
HARDWARE USED:
Figure 4
10
AVERTISSEMENT
Ne pincez pas les fils entre la tige de suspension
descendante et le support de suspension éviter toute
électrocution.
WARNING
To avoid possible shock, do not pinch wires between the
downrod and the hanger bracket.
AVERTISSEMENT
Si vous n'installez pas la languette dans la rainure, vous
risquez d'endommager les fils électriques et de causer
éventuellement une décharge électrique ou un incendie.
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
