OK
OK
System
Gradient
OK
OK
Gradient
1°C/s
OK
OK
Gradient
2°C/s
OK
OK
Gradient
3°C/s
OK
OK
Gradient
4°C/s
OK
OK
Gradient
6°C/min
OK
OK
Gradient
Off
ATTENTION: Cross acteable speed teperature change value
cause error with code 02.
9.
System -> Samples
. This parameter is use to set frequency
wiht will be update reprts from temerature sensor. frequency
could be change from range 1÷120 samples for minute. To
change sample frequency need to pass menu System ->
Samples , by buttons “UP” or “DOWN” set frequency and enter by
OK Return to main menu without save all changes is possible by
button return.
OK
OK
System
Samples
OK
OK
1/min
120/min
OK
OK
...............
Samples
Samples
10.
System-> Default settings.
Default settings make possibility
to return all settings of regulator to target values. If you need
restore default settings pass to menu System -> default settings
and enter by button OK. Next by buttons “UP” or “DOWN” set
value YES and push button OK.
OK
OK
OK
OK
System
Default sett.
Default sett.
NO
Default sett.
YES
Saved
YES
ATTENTION!
Return to default settings cause delete all earlier
configurations with saved programs.
Rest of parameters of regulators are set with values:
Menu -> Info
This Menu -> Info is use to display max and min values which
were registered by temperature sensor.
OK
OK
Hi+54°
Lo-23°
Info
MENU
Code :01
Error
Code :02
Error
Error codes
Wrong work of regulator is siganalize by blinkig display
illumination and dispaly error number code. Delete information
abaot error ( if break will be fixe) possible is by push button return.
Explain of error codes::
Cross acceptable range for reports from sensor C1.
Lack or break sensor C1.
Cross acceptable speed change temperature value
for sensor C1.
Mode
Manual
T1
0,0°C
T2
0,0°C
T3
0,0°C
T4
0,0°C
H1
0,0°C
H2
0,0°C
Delay to C1
0min
Dealy to C2
0min
Sensor correction C1
0,0°C
Sensor correction C2
0,0°C
Distincation
0,0°C
Password
Lack
Light
All time
Gradient
OFF
Sampling
30 samples/min
Language
poliash
Code :04
Code :03
Error
Error
Cross acceptable range for reports from sensor C2.
Lack or break sensor C2. (only for pgrograms which
use sensor C2 .
Cross acceptable speed change temperature value
for sensor C2.
