Fanaway LD-0003-11/CH/GS, Installation Instructions Manual, Page: 9 / 55

9
REVERSE FUNCTION
Your ceiling can operate either in fan mode or reverse fan mode.
SUMMER
Mode: The reverse switch shall be in “down” (SUMMER) position to make the fan rotate in the
anticlockwise direction. The airflow will be directed downwards, for cooling in summer.
WINTER
Mode: The reverse switch shall be “up” (WINTER) position
to make the fan rotate in clockwise
direction. The airflow will be directed upwards, for energy conservation in winter.
USING YOUR CEILING FAN
FAN WALL CONTROL
Turn on the power and check the operation of the fan.
• OFF Position –
fan off
• 3rd Positi
on
–
low medium fan speed
• 2nd Position –
medium fan speed
• 1st Position –
high fan speed
Light Control
• Toggle Switch –
on/off
AFTER INSTALLATION
WOBBLE:
The fan blades have been adjusted in the factory to minimize any wobble.
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY ARE
MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE CEILING IT
WOULD CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW CENTIMETRES IS QUITE
ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH SECURED THE
MOUNTING BRACKET AND DOWN ROD ARE SECURE.
BALANCING A WOBBLING CEILING FAN:
For your convenience, a Balancing Kit is included; please
follow this procedure when balancing the fan:
1) Install fan without light dome before balancing the fan.
2) Define the base plate into four areas (point A, B, C & D).
Use one weight from the balance kit to lightly stick on the
edge of the base plate (say point A), if the wobble
worsens, then take off the balance kit and lightly stick it
on the opposite side (say point B); if the wobble is worse,
then go to the adjacent point C or D, if the wobble gets