FANATEC CSL E RW PS4, Manual, Page: 35 / 41

35
Put the H-pattern shifter’s lever into the position shown on the LED display and
acknowledge each single position by pressing /
START (10) to get to the
next one.
The following pictures show the instructions on the LED display of the CSL Elite
Steering Wheel (PS4
TM
version) but are similar on the other Fanatec
®
steering
wheels:
. . . . . . . . . . . . . . . . neutral position
. . . . . . . . . . . . . . . . . . . . . . . . . . rear
. . . . . . . . . . . . . . . . . . . . . . . 1
st
gear
. . . . . . . . . . . . . . . . . . . . . . . 2
nd
gear
. . . . . . . . . . . . . . . . . . . . . . . 3
rd
gear
. . . . . . . . . . . . . . . . . . . . . . . 4
th
gear
. . . . . . . . . . . . . . . . . . . . . . . 5
th
gear
. . . . . . . . . . . . . . . . . . . . . . . 6
th
gear
. . . . . . . . . . . . . . . . . . . . . . . 7
th
gear
If your shifter has no 7th gear just acknowledge it by pressing / START (10)
when the shifter lever is physically in position of 6th gear. After all gears are
calibrated the LED display shows S_1 and the shifter is ready for use.
NOTE: If you did not intend to enter the shifter calibration mode sim-
ply complete the calibration process either without a connected shifter or
without moving the shifter lever. You may then leave the shifter calibra-
tion mode at the end of the process. This has no impact on the CSL Elite
Racing Wheel original calibration itself and you can go ahead without a
shifter.