5
For the rejection of more common trash metals and the detection of
most valuables, this should occur somewhere between the RINGS
range.
For the rejection of all trash metals, even though some valuables
will also be lost, higher rejection levels are useful.
3. FREQ
TUNE
Control
The FREQ TUNE Control eliminates cross talk or interference often
resulted by two or more detectors operating close together.
4. NORMAL/MAGNETIC
toggle
The NORMAL/MAGNETIC (sand) toggle allows the operator to switch
between two settings, NORMAL is best suited for normal conditions,
and MAGNETIC is best suited for extreme conditions such as black
sand, saltwater beaches or other highly mineralized ground. If
searching extreme conditions, use the Magnetic position in
combination with the detecting mode toggle (in the center DISC Mode
toggle position), and the DISC control setting within the TRASH Range
(Yellow Range). This will improve performance in extreme conditions.
5.
Detecting Mode toggle
The Detecting Mode toggle (located on the handle/rod) selects
between the two available operating Detection modes (DISC mode
and ALL Metal mode). The center position is used during most
searching where the rejection of trash metal is desired, based on the
DISC control setting. Temporarily squeezing and holding the toggle or
putting it in the locked forward position will provide superior pinpointing
when detection of all types of metal is desired. Temporarily squeezing
and holding the toggle offers all the advantages of the locked forward
position only once released, the toggle automatically returns to the
center DISC Mode.
