3. Now turn quadcopter ON by flipping the switch underneath the quadcopter to
the ON position. After about 3 second the controller will beep “di do di”.
The lights on the copter will stop flashing. This shows the quadcopter has
become bound to the controller.
4. Put the copter on level ground. Move the
RIGHT STICK on the controller in a circle.
The controller will beep “di do di” and
the copter lights will blink briefly. This
calibrates the copter gyroscopes for level
flying.
Power Switch
Push the LEFT STICK forward to
make the copter go up, or backward
to go down (throttle). The throttle
will stay where you leave it.
1. Up / Down (Throttle)
Push the LEFT ST ICK left or right to
rotate the direction the copter is
facing (yaw).
Release the stick to stop rotating.
2. Rotate Direction
3. Move Left / Right
If the copter drifts forward or back
when the stick is centered, click this
switch forward or backward until
the copter is stable.
7. Adjust Forward/Backward Trim (Pitch)
Push the RIGHT STICK left to move
left, or right to move right.
Release the stick to stop moving.
Push the RIGHT STICK forward to
move forward, or back to move
backwards.Release the stick to stop
moving.
4. Move Forward / Backwards
If the copter rotates when the stick
is centered, click this switch left
or right until the copter is stable.
5. Adjust Rotation Trim (Yaw)
If the copter drifts to the side when
the stick is centered, click this switch
left or right until the copter is stable.
6. Adjust Left/Right Trim (Roll)
FLIGHT CONTROL
7
8
OFF ON
