The Li-Po batteries may be recycled
Please discard old batteries in a proper recycling station.
Do not throw batteries in the regular trash. If you have questions,
please contact your local environmental agency to collect old batteries.
*Do not expose the charged battery to high temperatures, such as flames or near
electronic devices. This may cause damage or explosion.
*Make sure all batteries are connected in the proper orientation to avoid damage
or explosion.
*Do not use the battery to impact any hard surfaces. Avoid contact with metal.
*If the battery becomes damaged, bulges, or appears to change shape, please
stop using the battery and discard it.
*When charging the battery, to avoid accident, put the power supply on the ground.
Avoid setting the charger on cloth or other flammable materials because the
charger will get hot.
*Do not immerse the battery in water. The battery should be kept in a dry place.
*Do not break the battery or attempt to open the battery.
*Do not leave the battery charging without supervision.
2. Install Li-Po Battery in Quadcopter
Install To install the Li-Po battery in the quadcopter,
press the tab at the front of the battery compartment
down to access the battery compartment, and insert
the battery base-first into the compartment so that
the cable on the battery is exposed. To remove the
Li-Po battery from the copter, press down on the tab
with one hand and grasp the battery with your other
hand to pull the battery out by its sides (never pull
the battery out by its cables).
3. Connect the Battery
*For safety, make sure the switch beneath the copter is
in the OFF position before you electrically connect the
battery cables. Connect the battery to the quadcopter
by gently plugging the cable on the battery to the
power cable underneath the copter. Make the sure
receptacles are oriented correctly so that one
receptacle slides smoothly into the other.
*To disconnect the battery, grasp the plastic receptacles
with your fingers. Never pull the cables apart by pulling
on the cables.
NOTE: The copter will not operate unless you follow
these steps in the order listed.
1. First make sure the quadcopter is OFF. Turn
the controller / receiver ON. This procedure
must be followed precisely for the controller and
copter to find and bind with each other.
2. The controller will beep once and the light will
blink rapidly. Move the LEFT STICK to the top
and then to the bottom. The controller will stop
blinking to show the throttle is calibrated.
Leave the stick at the bottom.
Press Down on
Tab to Access
Battery Compartment
Connect Battery
1. Install 4 AA Batteries in Controller
To assemble the Controller, install 4 1.5V AA batteries (not included) in the
controller/ transmitter. You may need a small screwdriver to open and then close
the cover over the battery compartment.
FLIGHT PREPARATION
PRE-FLIGHT ADJUSTMENTS
5
6
