32
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
the front. Assemble the new switch to the bezel by
lining up the key sections and pushing home. Fit the
new button by pushing in from the front.
Replace facia panel in reverse order and test for
correct operation.
5. To Remove Electronic Timer
Disconnect from electricity supply.
Pull off the timer control buttons and remove the facia
panel (See 1). Remove the timer/mounting bracket
assembly from the facia by removing the two fixing
screws. Remove the timer from its mounting bracket by
depressing the plastic lugs on the timer case, at the
same time pulling the unit forward.
Reassemble in reverse order. When replacing leads
refer to the wiring diagram. Check operation of timer.
6. To Remove a Thermostat
Remove facia panel and RH hotplate tray - see 1 and
2.
L H oven
Open the oven door. Remove oven furniture
and slide out oven roof liner. Remove
thermostat phial cover (2 screws). Remove 2
screws securing the thermostat to its mounting
bracket. Remove the 6 screws securing the
rear cover and lift clear. Pull the thermostat
capillary out through the cooker back. From
the top pull the thermostat capillary up and
out. Disconnect the leads and remove the
thermostat and phial. When fitting replacement
thermostat ensure that the capillary is clear of
the terminals of the ignition generator. Clip the
phial to the oven back with the phial centrally
positioned between the clips. Reassemble in
reverse order. Check operation of thermostat.
RH Oven
Open the oven door. Remove oven furniture.
Remove the oven inner back fixing screws and
remove the inner back. Unclip the thermostat
phial from the clips on the oven back. From
the top pull the thermostat capillary up and
out. Disconnect the leads and remove the
thermostat and phial. Reassemble in reverse
order. Check operation of thermostat.
7. To Change Grill Controller
Remove the facia panel (see 1). Disconnect wiring from
controller. Remove 2 screws holding controller to
mounting panel. Fit new controller and reassemble in
reverse order. Check for correct operation.
8. To Change Warmer Switch
Remove RH hotplate tray. (see 2). Disconnect wiring
from Warmer switch. Remove 2 screws holding switch
to mounting panel, taking care not to lose the switch
rotation limiter. Fit new switch and reassemble in
reverse order. Check for correct operation.
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF GAS SUPPLY.
9. To Change Hotplate Control Tap
Remove the facia panel, see 1. Lift up the LH hotplate
tray front (see 2). Remove the heat shield (2 screws).
Undo the nut at rear of the tap and remove the
screw(s) securing tap to gas rail. Remove old tap,
discard old gasket/seal. Fit new gasket/seal to new tap.
Reassemble in reverse order. Check tap is adjusted for
correct gas. Check appliance is gas sound.
10. To Change Hotplate Burner
Injector
Standard burner Wok burner
A jet, B internal injector, C external injector
Remove burner cap and head. Remove old jet. Fit new
injector. Note the Wok burner has 2 injectors.
Reassemble in reverse order. Check appliance is gas
sound.
11. To Change Hotplate Burner
Electrode
Lift off pan supports, remove burner cap. Remove the
screw holding the electrode. Pull electrode vertically up
sufficiently to grip the lead between thumb and
forefinger. Pull off the electrode, but keep hold of the
lead. Fit new electrode to the lead. Fix electrode in
burner with screw. Replace burner cap. Check the
burner ignition. Replace pan supports.
