Falcon telecom SP-BT-POC, Manual

Page: 21 / 24

and mobile phone together within 1m and try to pair after entering password “0000
Fail to connect with mobile phone
Please make sure the mobile phone support Bluetooth function and Bluetooth HFP
related protocols
Fail to re-connect or automatically re-connect with mobile phone
First make sure your Bluetooth function in in your mobile phone have been turned on,
then remove all the matching information according to Bluetooth headset manual as well
as that of your phone. Then restart mobile phone and pair with Bluetooth speaker-mic
and set the headset read as “default/trust/test/permit automatically connection/always
visible/allow to be found” device, and further ensure that the phone prompt tone is not
vibrating mode (because the vibrating impulse wave would interfere with Bluetooth fre -
quency signal sometimes), then repair and connect with your mobile phone. For android
system, please make sure in the Bluetooth Speaker-mic device option list, you have both
“Phone” and “Media” options selected.
System halted
The system halts when strong radio frequency interference occurs. Like when nearby high
power TV transmitting tower, GSM base or airport radar, the speaker-mic may die. It can
be restored through recharge the device.
Abnormal instruction of Charging indicator
1) When the speaker-mic haven’t been used for long time or overused, it need to be
pre-charge for an hour, then pull out and in the charger, it will indicate normal charging.
Please don’t count the pre-charging time into normal charging time.
2) Try another charging line or charger.
Whether or not Support using while charging
Use while charging is not recommended.
Compatibility with other chargers
Cigarette charger of the car or motorcycle, emergency battery pack or other type charger
might be used for charging as long as their actual output voltage is between 5V to 5.5V
and have the same plug style and power source positive and negative polarities with our
initial charger. However the user will be responsible for the risk of using other chargers
and we don’t guarantee the effects and responsible for the risk.
Wrong operation into factory test or USB upgrade mode
The SP-BT-POC light indicator flashes abnormally and can’t power on after wrong
operation into factory test or USB upgrade mode. User must short push the reset port to
reset the device
Please send back your SP-BT-POC to our after-sales service department
for help if above 1 to 12 suggestions fail to solve your problem