3
Installation:
Bear Video Camera (Model #TBM-18)
1.
Power by either the Battery and DC power of the Bear video camera.
2.
Position the video camera in the desired location.
NOTE: The transmission range of the Bear video camera at open side up to 150 ft. Real
distance is depends on its operating environment. If you are receiving poor video images from
the camera, try shortening the transmission range. Reposition and/or adjust the Bear video
camera if video transmission is being degraded by obstructions in its operating environment.
3.
Select the desired transmission channel for the Bear video camera.
NOTE: The Model #TBM-18 Bear video camera has four (4) different transmission channels.
The Bear video camera has been set to transmit on CH 1 at the factory. Do not set and/or use
more than one (1) video camera on the same transmission channel in order to prevent signal
interference and unclear picture reception.
a. Remove the Channel Switch rubber grommet from the Bear video camera (front) base.
(Refer to the diagram in the “Equipment and accessories” section.)
b.
Use a small, blunted, pointed object to slide Channel Switch inside of the base opening,
as desired (Channel 1-4).
c.
Securely reattach the Channel Switch rubber grommet onto the video camera base.
NOTE: Reference the “Receiver (Model #VSB8RX)” section to update the receiver
channel selection.
4.
Open the Bear Camera Battery Zip put 9V battery in the battery room or connects the AC
Power Adaptor Jack end to the DC Input Jack end of the Bear Video camera.
5.
Plug the AC Power Adaptor into a standard 120V AC electrical outlet.
6.
Unplug the AC Power Adaptor from the electrical outlet when it is not in use or is left
unattended.
7.
When DV9V Plug in Jack the Battery power will Auto switch off.
8.
Please use 9V ALKALINE Battery for battery source
Receiver (Model #VSB8RX):
CAUTION: Make all of the necessary wire jack connections before plugging the AC Power
Adaptor into an electrical outlet, as a risk of electrical shock may exist. Keep away from water,
fire raindrop and high humidity
1.
Insert the 3.5Ø cable plug into the A/V Output Jack of the receiver.
2. Insert the (yellow & white) cable plugs into the Video Input and Audio Input Jacks of your TV,
as appropriate.