© Allegion 2018
Printed in U.S.A.
030794 Rev. 03/18-g
Timing instructions
For standard cylinder locks functions T351, T381, T561, T571
L
If cylinder and lever are installed, see "Remove keyed lever trim" for lever removal instructions.
7a
Using a thin flat screwdriver, turn the action bar slot clockwise until it stops at approximately 2:00.
7b Turn the action bar slot counterclockwise to the 9:00 position. Note: there is no physical stop at this location.
7c With the key out, install the standard cylinder into the spindle.
7d See "Reinstall cylinder levers (except IC)" for lever reinstallation.
7e Test key for proper operation.
Door edge
RH shown
Action
bar slot
7a
7b
For IC core cylinder locks functions T351, T381, T561, T571
L
If the IC core is installed, see "Remove IC cylinder levers" for IC core removal instructions.
7a
Using a thin flat screwdriver, turn the action bar slot clockwise until it stops at approximately 11:00.
7b Turn the action bar slot counterclockwise to the 7:00 position. Note: there is no physical stop at this location.
7c Using the control key, install the IC core cylinder into the lever and spindle.
7d Remove the control key
7e Test key for proper operation.
Door edge
RH shown
Action
bar slot
7a
7b
