19
Display & Controls
LCD Display
The diagram to the right shows all available icons of the front
panel LCD for the all SSG models. Refer to the LCD symbols
in the left-hand column, below for their functional definition:
Utility Power Status:
Line cord icon indicates utility
power is within specification.
PFC Status:
Sine wave icon indicates the input power
factor correction (PFC) is functioning properly.
Inverter Status:
Generator icon indicates the inverter is
functioning properly.
Charger Status:
Gas pump icon indicates the charger is functioning properly.
Output Load %:
The greater the load, up to three vertical bars will be illuminated at the top of
the weightlifter icon. Each bar represents approximately 25% of the UPS output rating.
Battery Mode:
Scissor lift icon indicates the UPS is in battery mode.
Battery Level:
Battery cell icon indicates the battery capacity. The greater the battery capacity
available, the more internal bars will be illuminated. Each bar represents 25% capacity.
Fan in high speed mode:
HS
fan icon indicates fans are in high speed mode.
Fan in medium speed mode:
MS
fan icon indicates fans are in medium speed mode.
Fan in low speed mode:
LS
fan icon indicates fans are in low speed mode.
BIT Window:
The bit window displays programmable settings and fault condition error codes.
Audible Alarm:
Speaker icon
indicates the audible alarm is on.
Test:
Test icon flashes indicating a battery self-test is being performed.
UPS Fault Condition:
Exclamation point icon
indicates an alarm condition exists.
Green Mode:
Bulb icon indicates the green mode function is enabled. It will flash when the UPS
has switched to green mode due to the UPS output load decreasing to less than 3% of the total
UPS output rating.
Metering:
Seven segment display provides readings for voltage, current, temperature, applied
load and frequency reported from the UPS.
