INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
27
Final Checks
Hotplate Check
Check each burner in turn. There is a Flame Supervision
Device (FSD) that stops the flow of gas to the burner if the
flame goes out. For each burner, turn the control knob to the
solid flame symbol. Press in the control knob. This lets gas
through to the burner. Keep holding the knob pressed in and
press the igniter button or light with a match. Keep holding
the control knob pressed in for about 10 seconds.
If, when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Oven Check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working.
Note:
The oven light bulb is not included in the guarantee.
Turn off the oven.
Final Fitting
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the range
(Fig.7-15)
. Fasten the plinth using
these screws.
Refit the Drawer
To refit the drawer, pull the side rails fully out. Carefully move
the drawer back between the rails and rest it on the side rails
(Fig.7-16)
.
At each side, hold the front of the drawer and pull the side
rail forward so that the clips click into position, holding the
drawer to the side rails
(Fig.7-17)
.
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking ‘U’ clips back to fit onto the hinges.
Customer Care
Installer:
Please complete your details in this Guide, inform
the user how to operate the cooker and hand oven the
instructions.
Thank you.
Make sure the inner
rail is forwards
ArtNo.281-0026 - Front plinth
Fig. 7.16
Fig. 7.17
Fig. 7.18
