INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
23
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base
(Fig.7-2)
. Repeat from the back and remove
the rear half of the polystyrene base.
Removing the Storage Drawer
Pull the drawer right out.
Push the ends of the plastic clips – down of the left-hand side,
up on the right-hand side – to release the catches holding the
drawer to the side rails
(Fig.7-3)
. At the same time pull the
drawer forwards and away from the side rails.
For safety’s sake push the drawer rails back out of the way.
Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position
(Fig.7-4)
. Grip
the sides of the door, lift upwards and then slide the door
forwards
(Fig.7-5)
.
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig.7-6)
.
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly.
Carefully push the cooker backwards off the pack base.
Remove the pack base. Position the cooker close to its final
position, leaving just enough space to get behind it.
n
n
DO NOT use the control knobs to manoeuvre the
cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker, turn the
adjusting nuts at the front bottom corners of the cooker. To
set the front feet turn the bases to raise or lower.
ArtNo.325-0002 - BI oven removing the door
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig. 7.3
Fig. 7.4
Fig. 7.5
Fig. 7.6
