Ver. 3/13
Attachment of Steam Hose
Insert the hose connector into the steamers vacuum-steam port as shown (fig. 8) by pressing the
plug into the port until button clicks. Check that the connector is firmly positioned by gently pulling
backward on it to ensure it is locked in place. Ensure that the hose is firmly connected to the
machine! To disconnect the hose from the steamer, press the connector button “A” (fig. 8) and pull
to separate it from the steamer
Machine Steam Function
Turn the main power switch on (fig. 9) to activate the display. Press button to turn on the boiler (fig.
10). The steam icon (fig.10) on the display will blink. When the steam icon stops blinking (about 10-
12 minutes) the steamer is ready to generate steam.
PLEASE NOTE:
Do not begin dispensing steam if the steam icon is blinking when first turned on. Wait
until the icon has switched to non-blinking mode and the system is ready to use.
Press the steam demand button (fig. 11) on the handle to start dispensing. Press the steam volume
adjustment button located on the top of the handle (fig.12) to vary the flow of steam. There are
three steam-flow settings as indicated by the LCD display (fig.10)
Some drops of liquid water may form when the steamer is first used. This is from condensation
within the sleeve. Aim the first steam jet toward a piece of cloth to catch the liquid until the jet
becomes uniformly steam.
Steam/detergent function
Press detergent button on the control panel (fig. 10). The detergent icon on the display will start to
blink. The machine is now ready to dispense detergent on demand.
To dispense detergent, press the detergent on/off button on the operators handle (fig.12). This
enables the pump to deliver the detergent solution when the on demand steam button is activated
(fig. 11).
The unit will continue to dispense detergent until it is turned off. To turn-off the detergent function,
press the on/off button
once
. The icon will flash to indicate this function is now disabled. To turn off
the detergent function completely, press the red button on the control panel
once
(fig.10).
No water
When there is no water in the water reservoir the no water icon on the display (fig. 10) begins to
blink, along with an audible alarm. To refill the tanks, follow the “filling water and detergent tanks”
instructions above.
13