Falcon Nexus 110 Induction, User'S Manual & Installation Instructions

Page: 49 / 56

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
45
ArtNo.320-0002a Proplus oven door side screws
6.5 To Change the Oven Door Latch
Remove the outer door panel (see 6.4). Remove screws ‘B’,
which hold the latch assembly to the inner door panel
(
Fig. 9.10
). Fit the new catch and reassemble in reverse order.
Check the door operation.
6.6 To Adjust an Oven Door Catch Keep
Open the oven door, slacken off the locknut at the base of the
keep, and screw in or out as required until the required fit is
obtained. Retighten the locking nut (
Fig. 9.11
).
6.7 To Change an Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until that hook is released (
Fig. 9.12
).
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are stiff, as the old seal will be
discarded.
When fitting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of the
door, and proceed round the door, snapping in each hook in
turn.
6.8 Oven Door Glass
The glass on the oven doors is not replaceable.
Fig. 9.9
Fig. 9.10 Fig. 9.11
Fig. 9.12
ArtNo.320-0005 Oven door rubber seal
ArtNo.320-0003 Oven door latch
B
ArtNo.320-0004 Oven door keep