FILLING LEVEL
Single Purpose Pans
Normal capacity is up to the maximum level mark on rear of pan wall, 75mm below brim. This
capacity should never be exceeded if boil over is to be avoided.
Warning: This appliance should not be used filled below the minimum level mark.
Dual Purpose Pans
Outer Jacket
The level is correct when 50mm of water - up to level mark within filler funnel - is evident when
inner pan is clamped in position.
Inner PAN
This should be filled to no more than outer pan brim level.
GAS CONTROL (Figure 2)
There are four set operating positions as illustrated:
Position 1
Burner & pilot
OFF
Position 2
Pilot ignition or
Pilot ON only
Position 3
Burner FULL ON
Position 4
Burner ON at
LOW rate
Due to a built-in safety stop, it is necessary to push knob inward before trying to turn it from off to
ignition and from ignition to off.
The burner can be regulated between full on and low rate as required. Settings are generally
determined by experience.
