KNQK
Drain Hose Connection
Insert the drain hose into a drain pipe with a
minimum diameter of 4cm,or let it run into the
sink,making sure to avoid bending or crimp-
ing it.Use the special plastic support that
comes with the appliance (see fig .C).The free
end of the hose must be at a height between
40 and 100 cm and must not be immersed in
water.
Attention:
The special plastic hose support must be sol-
idly fastened to the wall to prevent the drain
hose from moving and allowing water to spill
outside the drain.
Electrical Connection
After making sure that the voltage and fre-
quency values for the current in the home cor-
respond to those on the rating plate(located
on the stainless steel inner door of the
appliance) and that the electrical system is
sized for the maximum voltage on the rating
plate,insert the plug into an electrical socket
which is earthed properly (the earthing of the
appliance is a safety requirement mandated
by law).
If the electrical socket to which the appliance
must beconnected is not appropriate for the
plug,replace the plug ,rather than using
adpators or the like as they could cause over-
heating and burns.
Installation
fig.C
Summary of Contents for FDW2002
Page 16: ...Installation Diagram ...
