![background image](http://html.mh-extra.com/html/falcon/fdw2002/fdw2002_user-manual_539823014.webp)
KNPK
Installation
Positioning the Appliance
Positioning the appliance in the desired
location.The back should rest against the wall
behind it,and the sides,along the adjacent cabi-
nets or wall.The dishwasher is equipped with
water supply and drain hoses that can be po-
sitioned to the right or the left to facilitate proper
installation.
Levelling the Appliance
Once the appliance is positioned,adjust the
feet (screwing them in or out) to adjust the
dishwasher,making it level.In any case,the ap-
pliance should not be inclined more than 2
.
If the appliance is level,it will help ensure
proper performance.
Cold Water Connection
Connect the cold water supply hose to a
threaded 3/4(gas)connector ,inserting the
small filter supplied with the dishwasher and
making sure that it is fastened tightly in place
( s e e f i g . 1 / A ) . S o m e m o d e l s h a v e a n
"Acquablock" water supply pipe (see fig.1/B)
with filter in the threaded inlet.
If the water pipes are new or have not been
used for an extended period of time,let the
water run to make sure that the water is clear
and free of impurities.If this precaution is not
taken,there is a risk that the water inlet can
get blocked and damage the appliance.
Hot Water Connection
The water supply to the appliance can also
be connected to the house's hot water line
(centralised system,heating system),as long
as it does not exceed a temperature of 60
.
In this case,the wash cycle time will be short-
ened by about 15 minutes and the wash effi-
ciency slightly reduced.
The connection must be made to the hot wa-
ter line following the same procedures as
those for the connection to the cold water line.
1/ B
1/A
fig.1
Summary of Contents for FDW2002
Page 16: ...Installation Diagram ...