SECTION 3 - CLEANING and MAINTENANCE
It is important to clean the air intake filter regularly.
The filter is located below body at front centre. It can be
removed by sliding out of the front. Clean using hot,
soapy water and re-fit after drying.
(Refer to Figure 5)
Failure to clean the filter regularly may cause
problems which will not be covered by warranty.
The air intake filter MUST ALWAYS BE IN POSITION
during operation!
The wok indent can be wiped clean using a damp cloth
and warm, soapy water. For heavy stains, use a scraper
whilst zone is still warm then wipe down when cool with
a damp cloth.
NEVER USE a spray jet to clean this appliance.
ERROR CODES
DO NOT remove or attempt to repair or replace ANY part
or parts of this appliance other than the air intake filter.
If an error occurs within the unit, the control panel LED
will flash to indicate an error code.
There will be one long flash followed by a series of shorter
flashes. The number of
“short”
flashes corresponds to the
number in the
“code”
column of the Error Code Table -
ie. 5 short flashes corresponds to error code
05 - Control
Unit Failure.
The error code list on pages 5 and 6 will help identify the
faulty component.
In the
“action by user”
list, you should follow the action
listed,
before contacting a Service Engineer.
Key to unit symbols
Non-ionizing, electro-magnetic radiation.
Dangerous voltage
Equipotentiality
4
SECTION 5 - TROUBLESHOOTING
Note: Most faults can be rectified by simply
switching unit off for 10 seconds. After this time,
turn power back on at mains supply.
If fault continues to occur after this action, refer to
table. This will provide a solution to rectify condition.
ERROR CODE TABLE
If any fault occurs during use, an error code
corresponding to the table details will be displayed
as a series of flashes.
For example, 5 short flashes followed by a long flash
would indicate error code 0.
The codes will assist to determine unit faults and the
actions required to remedy any such fault.
Note: most errors can be rectified by simply
switching the unit off at the main supply for
10 seconds and switching back on.
