17
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fit the levelling tool on the rectangular adjuster as shown
below.
LOWER THE FRONT ROLLER by doing 14 complete (360°) turns
clockwise. (This means turning and removing the levelling tool
56 times).
LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut as
shown below.
Make 10 complete (360º) turns clockwise. (This means turning
and removing the levelling tool 20 times).
ArtNo.010-0003 Lowering the rear rollers
x10
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of the pack base tray, and then, having
opened the grill door and right hand oven door so that you
can get a good grip under the fascia panel, lift the front of the
cooker:
Position the cooker close to its final position, leaving just enough
space to get behind it.
Do not move the oven by pulling the
door handles or knobs
.
Levelling
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level. Place the cooker in its intended
position, taking care not to twist it within the gap between the
kitchen units, as damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. Set the rear of
the cooker to the desired height, by using the levelling tool to
turn the adjusting nuts at the front bottom corners of the cooker.
Then adjust the height of the front feet/roller to level the cooker.
Once you are satisfied with the height and level, raise the front
of the cooker by one turn of the front roller adjuster. Then screw
down the front feet to meet the floor. Screw the front roller
adjuster anticlockwise to raise the front roller so that the front
of the cooker is supported on the feet,
not
the front roller, to
prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of
the tool facing the rear of the cooker, so that the customer
can use it if they wish to move the cooker.
Replace the drawer by locating on side runners and push in.
Fitting a stability bracket
It is advisable (although not mandatory) to fit a stability bracket
or chain to the cooker. When fitting the bracket, read these
instructions together with the leaflet supplied with the bracket.
1. Place the cooker in its intended position and level the
cooker.
2. Draw a pencil line 70mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring 550mm
from the left hand side of the cooker.
