13
For each side, support the side rail with one hand and with
the other hand lift the frame up and out of the side clips:
For safety, push the side rails back into the grill chamber. If
you need to remove the side rails to make cleaning the grill
chamber easier, you can unhook them from the grill chamber
sides and wipe the sides clean with a soft cloth and mild
detergent.
Do not
use any abrasive substance.
DO NOT put the side runners in a dishwasher.
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, ensure that the wide rim is at the
front:
Control Panel and Doors
The control panel and knobs, and oven doors, should only be
cleaned with a soft cloth wrung out in clean hot soapy water.
They can then be polished with a dry cloth.
Cookers with window doors
Each oven door front panel can be taken off so that the glass
panels can be cleaned. If the top edge of the oven door of
your cooker has a line of holes and there are screws in the
side edges, then it can be taken apart for cleaning.
Move the cooker forward to gain access to the sides (see the
‘Moving your Cooker’ section of these instructions).
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side):
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned - take care not to disturb or
wet the door insulation.
Please note that the door is triple glazed but that the inner
two panels are fixed and should not be separated. After
cleaning, carefully refit the outer door panel and replace the
side fixing screws.
Oven Panels
Both the ovens have panels which have been coated with a
special enamel that partly cleans itself. This does not stop all
marks but helps to reduce the amount of manual cleaning
needed.
The Cook & Clean panels work better above 200°C. If you do most
of your cooking below this temperature, occasionally remove
the panels (after removing the shelves), and wipe with a lint free
cloth and hot soapy water. The panels should then be dried and
replaced and the oven heated at 200°C for about one hour. This
will ensure that the Cook & Clean panels are working effectively.
Don’t use steel wool or any other materials that will
scratch the surface.
Troubleshooting
A crack has appeared in the hob surface
Disconnect the cooker immediately from the power supply
and arrange for its repair. Don’t use the cooker until after the
repair.
My hob is scratched
Always use the cleaning methods recommended in this
guide, and ensure that the pan bottoms are smooth and
clean.
Marks from aluminium and copper pans as well as mineral
deposits from water or food can be removed with a cleaning
cream. However, tiny scratches are not removable but will
become less visible in time as a result of cleaning.
The oven fan is noisy
The note of the oven fan may change as the oven heats up
- this is perfectly normal.
