28
Australia
Wall Attachment
When fl oor attachment is impracticable and provided that
the anti-tip bracket base can be securely fi xed to a solid wall
or wall stud. Discard Key No 2.
For both fl oor and wall attachment it is essential to
use the appropriate fi xing screws and to ensure that
the Anti-Tip Bracket is fi rmly attached .
Gas Connection
The Gas sup ply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
view from the back
A position for gas supply connector
B appliance gas inlet
Because the height of the cooker can be adjusted and
each connection is diff erent it is diffi
cult to give precise
dimensions. Ideally the house supply connection should be
in the shaded area shown in the diagram. Means of isolation
must be provided at the supply point by either an approved
quick-connect device or a Type 1 manual shut-off valve.
The hose should be fi tted so that both inlet and outlet
connections are vertical so that the hose hangs downwards
in a ‘U’ shape.
The connector is located below the hotplate level at the
rear of the cooker.
A fl exible connection is supplied with the cooker. If it is
necessary to use another hose it must be to A.S. 1869 class
B and suitable for your gas type. If in doubt contact, your
supplier.
To prevent strain on the connections to the cooker the
restraining chain should be used.
Securely fi x the supplied wall bracket to the fabric of the
building and clip the supplied restraining chain to the
bracket.
Measure the length of chain required. Use the clamp
supplied to clamp onto the gas pipe as shown.
Hook the other end of the chain to the wall fi xing.
After completing the gas connection, check the cooker
is gas sound with a pressure test. When checking for gas
leaks do not use washing up liquid - this can corrode. Use a
product specifi cally manufactured for leak detection.
Natural Gas
The adjustable spring loaded gas pressure regulator is
pre-set to give a nominal pressure of 1kPa on NG. Connect
to the Rp
1
/
2
inlet on the underside of the gas pressure
regulator.
Propane
This cooker is supplied ready for use on natural gas. A
conversion kit for Propane gas is supplied with the cooker
- see the conversion instructions in the next section.
Pressure testing
Pull the cooker forward, if necessary, to gain access to the
rear.
The pressure test point is accessible on the connector block
at the centre rear. Remove the test nipple screw and fi t a
pressure gauge to the test point. Turn on and light 2 of the
hotplate burners.
See Technical data section at the back of this book for test
pressures.
Electrical Connection
WARNING: THIS COOKER MUST BE EARTHED.
All external wiring must comply with the IEE Regulations
for the Electrical Equipment of Buildings. Connection to the
