INSTALLATION
Check the appliance is electrically safe when you have finished.
27
ArtNo.010-0004 Moving the cooker
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (
Fig. 8.5
). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower
BOTH REAR ROLLERS
.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(
Fig. 8.6
).
Carefully push the cooker backwards off the pack base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n
Do not use the door handles or control knobs to
manoeuvre the cooker.
Fitting the Stability Bracket
Suitable stability devices are shown in
Fig. 8.7
and
Fig. 8.8
.
If you are using a stability bracket (
Fig. 8.7
and
Fig. 8.8
), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Repositioning the Cooker
Following Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(
Fig. 8.6
), you need to check behind the cooker to make sure
that the electricity cable is not caught.
As you progress, make sure that the electricity cable always
has sufficient slack to allow the cooker to move.
When you replace the cooker, again check behind to make
sure that the electricity cable is not caught or trapped.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level. Place the cooker in its intended
position taking care not to twist it within the gap between
the kitchen units as damage may occur to the cooker or the
units. The front feet and rear rollers can be adjusted to level
the cooker. To adjust the height of the rear of the cooker, use
a 13 mm spanner or socket wrench to turn the adjusting nuts
at the front bottom corners of the cooker.
To set the front turn the feet bases to raise or lower.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical floor mounting
Typical floor mounting
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting
Typical wall mounting
Fig. 8.5
Fig. 8.6
Fig. 8.7
Fig. 8.8
