AERO-VENT POLYCARBONATE WINDSHIELD:
10.
Install using the directions included with the windshield.
TOP CAP:
11.
After the windshield is installed take the soft Top Cap and put it over the top of the vehicle and make
sure you have the on correctly. When put on correct the sides will match up with the shape of the roll
cage. On the front you will take the shorter straps and wrap the looped end around the roll cage just
below the bottom clamp on the top section of the windshield. Run the other end of the strap through the
loop and pull it tight. Then run the strap up and through the buckle sewn to the corner of the top.
The
front strap should look like the photo below.
12.
Next take the other two long straps and wrap them around the roll cage in the rear just under door and
rear window at the very bottom of the roll cage. Pull the strap up and connect to the buckle at the rear of
the top.
