5.
Once all the Velcro is in place the last thing to do is install the screw snap studs. NOTE:
The best way
to install the snap studs is to put them in the sockets in the door first. Then push them into the
plastic to make a mark. Then pull the screw stud out and screw it into the plastic where the mark
was made. See Photos Below.
REAR WINDOW:
6.
Begin by placing the 30" adhesive Velcro strip centered across the top of the roll cage. Make sure to
place them on top of the bar.
7.
Next place the 55” strip across the bottom of the frame. It goes on the metal strip that faces the rear of
the vehicle.
8.
Then take the Rear Window and attach it across the bottom first making sure that it is centered properly.
Pull it up and attach the top.
9.
Next attach the sides of the Rear Window to the tabs on the back of the doors. See photo below.
