Lumina 17
Installer
28
Description
Setting of the name of the function.
Temp. inputs
Setting the addresses of the analog inputs. If the temperature sensors have not been
assigned, the control computer will use the house temperature.
Output address
Setting of the analog output address.
Analog type
Setting indicating the analog control type
During Mech. Vent.
Setting if the air inlet is open or closed during this phase.
•
FOLLOW COMBI
: according to the percentage in the combi-table (normal setting).
•
CLOSED
: close (the curtain at the side of house where the fans are placed must be
closed during mechanical ventilation).
Position wind side
Setting of the compass positions, which represent the wind side of the house. If the wind
comes from this direction (positions), the ventilation control may be influenced.
Position lee side
Setting of the compass positions, which represent the lee side of the house. If the wind
comes from this direction (positions) under wind side, the ventilation control may be
influenced.
Modulate link
Setting indicating if these air inlets are to be included in modulating ventilation — if
modulating ventilation is used.
Pre-run time*
Setting of the time in which the air inlets go to the required position, before the fans
activate.
INSTALLER
VENTILATION
INLETS
tab page
Extra
Description
Setting of the name of the function.
Output address
Setting of the analog output address.
Analog type
Setting indicating the analog control type
Position wind side
Setting of the compass positions, which represent the wind side of the house. If the wind
comes from this direction (positions), the ventilation control may be influenced.
Position lee side
Setting of the compass positions, which represent the lee side of the house. If the wind
comes from this direction (positions) under wind side, the ventilation control may be
influenced.
Modulate link
Setting indicating if these air inlets are to be included in modulating ventilation — if
modulating ventilation is used.
