BOLERO40 Series Promotion Kit
Version 1.0.1
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 9 of 21
3.
Now, unpack the power supply from the box and plug it into the left input socket on the control-box
marked "INPUT 12.0V … 32.0V”. Then plug the AC adapter into the wall socket of your 220V electric
mains (to access British/American wall socket use the included UK/US adaptor accordingly).
4.
The internal battery in the device may be shipped with a minimal charge and will need to be fully
charged before use. To charge the internal battery, follow the steps below:
a)
After connecting the AC adapter to the Control-Box and into the wall socket, apply power to
the control box and BOLERO45/41 device by turning just the “
+IN
” switch to “
ON
” position.
Figure 5:
Overview of the control-box top panel (+IN = ON)
b)
Depending on the battery charge state, the charging time may by different but usually it
takes 2-3 hours to fully charge the internal battery.
5.
After the battery is fully charged, unpack the USB to serial converter and the USB extension cable.
Remove the USB cover on the converter and connect the USB cable to the converter (1), see figure
below. Plug the serial port of the converter to the COM port of the control box (2). Finally, plug the
other end of the cable into a free USB port on your PC (3). This cable is used for communication
between the BOLERO45/41 and Workbench software for sending and receiving data as well as to
change the configuration stored in the BOLERO45/41 device.
Figure 6:
Connecting the converter with the USB cable
6.
Finally, power up the BOLERO45/41 device by turning the “
IGN
”-switch to "
ON
" position.
“
+IN
”
It supplies power to the control box and the connected BOLERO45/41 device.
“
IGN
”
It wakes up the BOLERO45/41 from IGN-Sleep mode.
Figure 7:
Overview of the control-box top panel (IGN = ON)
