31
4.
Now the pump can be connected to the power, disconnect the
cut-off cable which is already connected to the pump and
connect the power cable that runs out of the control unit to the
pump like in fig.10.
Mounting the telescopic swing arms
CAUTION! The lift needs to be in the lowest position, otherwise the
arms are locked. When mounting the arms, take into account that the
shorter telescopic arms are to lift the front end of the vehicle.
1.
Remove circlip from the pin (2, fig.11) and then remove the pin
out of the arm (1, fig.11).
2.
Grease the pin and toothing of the arm with EP40 multigrease,
also grease the toothing of the lifting body (3, fig.11) its locking
system.
3.
Place the arm in the recess in the lifting body and allign the
holes, then put the pin through.
4.
Now place the rubber pad, remove the circlip with circlip pliers,
place the rubber pad. Place back the circlip when the lift is in
raised position, DO NOT FORGET.
5.
Repeat steps 1 to 5 for the other arms, when the arms are in
lifted position, place back the circlips over the pins (2, fig.11).
Mounting the flexible column covers
1.
Loosen the nuts and washers on the upper end of the flexible cover.
2.
Put the two threaded ends through the holes in the top of the column and screw the washers
and nuts back on to secure the flexible cover.
3.
Now slide the flexible cover through the recess in the lifting body (fig.12a).
4.
Mount the bottom end of the flexible cover to the bottom of the column using the springs
(fig.12b).
Mounting the remaining parts
Mount the rubber protective pads for the doors to the lifting body with the M6 allenbolts.
Fig.11
Fig.12a
Fig.12b
Fig.10
