Fitting the Chimneys to the Extractor:
Slide the top chimney piece (this is the one with the vents holes cut
into the sides) into the bottom section (this one is solid, with no vent
holes).
1.
Adjust the total chimney length, by sliding the two chimney sections to
the required length. Once the required length is determined, fix the
bracket with the provided screws as shown in the picture below:
2.
Drill 2 x 8mm holes to accommodate the Plate II.
Screw and tighten
the plate II onto the wall with the two screws provided.
Fit the chimney section on top of the extractor and fix it in place with
the screws.
Upper Chimney
Bottom Chimney
Plug
Plate II
Screw (4mm x 8mm)
Screw
(4mm
x
9
