Fala 75945, Manual

Page: 10 / 71

10
GB
O R I G I N A L I N S T R U C T I O N S
DEVICE CHARACTERISTICS
Bathroom pump is designed for connecting sanitary appliances such as shower trays and washbasins to sewage network. Due
to the fact that it pumps impurities, it may be installed in places where the sewage infrastructure requires installation of forced
circulation e.g. below the connection or far from the intake. Product has been designed to be used only in households and may not
be used as a professional tool, i.e. in industrial plants and for economic activity. Correct, reliable and safe operation of the product
depends on proper installation and operation, therefore:
Before starting the work with this appliance, please read this manual and keep it properly.
Note! The pump is not designed for pumping faeces and impurities containing solid matters. It is forbidden to pump
liquids other than water and water sewage. Do not connect the pump to toilet bowl.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.
DEVICE ACCESSORIES
The pump is delivered complete and does not require assembly. Only proper installation is required for proper pump operation.
It is required that installation of water connections is carried out by a qualifi ed technician. The pump is delivered together with:
check valve and band clips.
TECHNICAL PARAMETERS
Parameter Measuring unit Value
Catalogue number 75945
Rated voltage [V~] 220-240
Rated frequency [Hz] 50
Electrical insulation class I
Protection class IPX7
Rated power [W] 250
Max. sewage temperature [
O
C] 50
Rotational speed [min -1 ] 2800
Max. capacity [l/min] 100
Max. pumping altitude [m] 5
Diameter of water connection [mm] 2 x Ø40; 1 x Ø25/32
Weight [kg] 4
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.