11
The Power Boost Mode enables an initial short term high power pulse applied to the coil (boost). The boost power is the value of the
parameter “Power Limit”. Beside 3 selectable initial boost lengths, further options generate a periodic boost pulse with different length and
repetition rate. An initial boost is for quick coil heat-up. The periodic boost lets the coil temperature pass a certain range all the time. In this
case different flavors within the liquid, which all develop their taste at different temperatures, are all addressed by the varying temperature.
We recommend to set the normal power (not the boost) to much lower values, when using the periodic boost, because the average
power is increased by the boosts and temperature gets higher therefore.
0 OvrVolt:
The input voltage is too high. The dicodes 2395 is prepared for the use of one or two batteries. If the input voltage
exceeds 9V this error message is displayed.
1 ChkAtom:
No atomizer detected or open coil.
2 TempRef:
A problem during the temperature reference measurement occurred Repeat the calibration procedure.
4 OverCur:
Short on coil or coil breakdown (open)
5 LowBat:
The battery voltage under load (with current drained from it) has reached the minimum discharge level, defined with
parameter UbatMin in the extended function mod-menu.
6 EleHot:
The electronics have heated up too much and needs to cool down. This error will not occur with normal usage of the
mod.
7 TimeOut:
The maximum puff-time is limited depending on power. For a power <20W it is 20 seconds. Above 20W it decreases
by 0.5 seconds per Watt, and from 40W it is kept at 10 seconds.
7.3 Mod Menu
8.
ERROR MESSAGES
Summary of Contents for Illusia C
Page 1: ...ILLUSIA C USER MANUAL ...
