9
EN
NOTE!
To select the intensity level, press on/off/energy selection button. Based on the level
you have selected, the intensity level LED indicator lights will flash between the
levels 1-5. By using the on/off/energy selection button (3), you can move forward up
to the 5th level and then go back, according to the level of intensity you prefer.
3. In order to initiate a light pulse at first level, press the start button (2) and place the
light surface on the skin. Ensure that the light surface (6) and the skin contact sensor
come in full contact with the skin. When the on/ready/off indicator light (4) flashes green,
it means that the light pulse is ready for application. The light pulse may be initialized
only when the skin contact sensor contacts the skin completely. You will see a red light,
hear a crackling sound, and feel a little burning and heat.
4. Place the skin contact sensor to another application area. By pressing the On/Off/
Energy selection button (3) once more, increase the intensity level. The device will be
ready shortly. Apply a light pulse using the start button (2). Do not set the device higher
than the maximum intensity level allowed/recommended for your skin tone (see the hair
and skin colour table behind the user manual).
5. If you feel uncomfortable after applying the light pulse, please decrease the intensity
level.
6. End the skin sensitivity test. Wait for 48 hours and then check the skin surface that
you performed the test on. If the skin looks normal (no reaction or mild rash) you can
use the appliance on the tested skin areas, at the intensity level you have set on the
skin sensitivity test.
NOTE!
If the skin surface reacts to the application (e.g. rash or swelling) wait until the
reaction is completely gone. Then perform another skin sensitivity test at a lower
intensity level. If any skin reaction occurs again, seek medical advice.
3.Application
1. Attach the power cable to the appliance and then plug the adapter into the outlet. The
on/ready/off indicator light (4) will turn orange.
2. Press ON/OFF/Energy selection button (3). The On/ready/off indicator light (4) will
turn green and the LED indicator lights will flash three times. If you press the button
once, the 1st level of intensity light will illuminate and the fan will start.
3. If you want to resume the implementation at a higher intensity level, press ON/OFF/
Energy selection button (3) until the intensity level you prefer is selected.
4. Place the light surface to the skin and press the start button (2) to initiate the light
pulse. Ensure that the light surface and the skin contact sensor come in full contact with
the skin. The light pulse may be initialized only when the skin contact sensor contacts
the skin completely. When the on/ready/off indicator light (4) flashes green, it means that
