10
EN
the light pulse is ready for application. You will see a red light, hear a crackling sound,
and feel a little burning and heat. To increase the energy level, press the On/Off energy
selection button (3). The device will be ready for the next light pulse in 1-3 seconds
(based on the intensity level) and the on/off/ready indicator light (4) will flash in green.
NOTE!
If the device is not used for at least 5 minutes, it will automatically switch off and the
On/Ready/Off indicator light (4) will turn orange.
3.1. Application methods
WARNING!
In an application session, do not apply twice to the same area. Applying more than
once to the same area increases the adverse effect risk.
NOTE!
Light pulses of the device should be applied in sequence. During the process, you
can follow a certain path (left - right or up - down) to apply light pulse to your skin.
Following a sequence allows better control on the skin area and prevents repeated
applications on the same area.
1st application method - “slide application” function:
Press and hold the start button. As the skin contact sensor completely
contacts the skin, the device will apply subsequent light pulses. After
each light pulse, slide the device to the next area. Continue applying the
light surface on the skin. This mode is appropriate especially for large
areas such as the legs.
NOTE!
If the device-skin contact is interrupted for more than 2 seconds, the slide application
function will become inactive. When you use slide application function, keep the
device in contact with the skin and keep sliding it.
