Fakir INOVAX, User Manual

Page: 40 / 106

40
EN
2) Suction power setting
– The suction power is adjustable by A5 button or by C2 switch if you use the extension piece
C. Three suction power levels are available (high, medium and low – SILENT mode).
NOTE!
– The vacuum cleaner is set to low suction power when switched on.
Dust container (B)
If you find out that the suction performance of the vacuum cleaner is reduced, make sure that
the dust container is not full and if necessary, empty it. Put the container above
a dust bit and press button B6; thus you will lift off bottom and throw the dust in common
municipal waste (Fig. 7). Snap the bottom shut to secure it in the opposite direction. For
sanitary reasons we recommend emptying the container outside housing premises
After about 5 emptying of the container we recommend complete cleaning of the filtration
system to remove the settled dust. Press container lock button B5 and then remove container
B from the vacuum cleaner (Fig. 7). The separátor B3, HEPA-filter B1 and foam micro-filter
B2 pull it out of the container. Tap the dust out of the HEPA filter over a dustbin or to clean the
filter through a blowing (we recommend the filter cleaning outside of living area for hygiene
reasons). If the protection micro filter is very dirty, you can also rinse the pleated side of the
HEPA filter under lukewarm slow-running tap. Hold the filter in such a way that the pleated
side points upwards and the water flows parallel to the pleats. Hold the filter at an angle so
that the water washes away the dirt inside the pleats. Turn the filter 180° and let the water flow
along the pleats in the opposite direction. Continue this process until the filter is clean. After
drying, insert the cartridge back to the container in the opposite way.
Clean all other parts (i.e. container, separator, foam micro-filter) in running lukewarm
water, e.g. using a cloth or a soft brush and let it dry completely. Re-assemble individual
parts in the opposite direction.
D – Dust container
If you find out that the suction performance of the vacuum cleaner is reduced, make sure
that the dust container is not full and if necessary, empty it. Press container lock button E2
and then remove container D from the extension adapter E (Fig. 8). The suction chamber lid
D1, filter D2 and separator D3 pull it out of the container. Clean all parts in running lukewarm
water, e.g. using a cloth or a soft brush and let it dry completely. Re-assemble individual parts
in the opposite direction.
Storage
Store the appliance thoroughly clean on a dry, dustless place out of reach of children and
persons sui juris. Do not put the assembled rod vacuum cleaner on an uneven surface!
The cleaner must be placed on a flat surface where there is no danger of knocking over.