11
ATTENTION:
Do not vacuum without the
dust bag.
ATTENTION:
Replace the dustbag when
the vacuum cleaner is not connected to the
mains.
• Remove the hose from the air-inlet.
• Open the dust compartment cover (1) by
unlatching and susequently raising it up to
the highest position until it locks byself.
Note:
Be careful when removing the dust
filter bag so that no dust escapes!
• Pull the dust filter bag (1) up and out of the
dust filter holder.
• Remove any dust that have may collected
in the dust compartment.
• Push the new dust filter bag in the filter bag
holder.
• Close the dust compartment cover. ‹t clicks
into place audibly.
Note:
The dust compartment cover can
only be closed with a dust filter bag in
place!
AIR-INLET FILTER REPLACING
• Switch off the vacuum cleaner and open
the vacuum cleaner such way as in case
of dust bag replacing,
• Remove the filter holder with air inlet filter(1).
Your first flip the filter holder forwards and
then pull the filter up and out.
• Remove the air inlet filter(1) from the filter
holder(2).
• Clean the filter holder.
• ‹nsert the new new air inlet filter into the
filter holder.
• ‹nsert the filter holder with new air inlet filter
into its bracket from nabove and push it
down until it audibly locks into place.
• Replace the dust filter bag and close the
dust compartment cover. The cover clicks
audibly into place.
ATTENTION!!! This filters are not washable.
The exhaust filter may be not re-used.
AIR-OUTLET FILTER REPLACING
• Switch off the vacuum cleaner and open
the vacuum cleaner such way as in case
of dust bag replacing.
• Remove the exhaust filter(1). Unlatch the
lock and slightly lift the filter.Now you can
pull out the filter towards the front.
• ‹nsert a new filter push it down slightly until
it locks into the holder.
• Replace the dust filter bag and close the
dust compartment cover. The cover clicks
audibly into place.
Note:
Make sure that the exhaust filter is
always properly locked into position,
otherwise the exhaust air will be not properly
filtered.
