Stud Detection Procedure
1.
Set the selector switch to "
STUD
" position.
2. Calibration
:
Place the unit against wall. Depress and hold the
TEST
button down, the detector will begin calibration.
When it sounds two beeps, the calibration is
complete. Always keep the
TEST
button depressed
throughout all the following procedures.
3. Detection:
a.
Place the detector on the surface and slowly move
the unit sideways (fig 1). When the detector moves
closer and closer to the stud, the signal LEDs will
light sequentially from bottom to the top. When the
top signal LED lights and the built-in buzzer
sounds continuously, the unit has detected the
stud's edge. Stop moving and mark a spot in the
detectors groove on the walls surface (fig 2).
5
OPERATING INSTRUCTIONS
Fig.1
Fig.2
Fig.3
