EN
User Manual
o
perating
ManUal
of
f
aHrenHeit
soldering
station
Soldering iron stand
Wet the sponge before use the stand, and press out the extra water, but
keep it moisture. Place the sponge into the stand. If you use dry sponge
it may cause damage on the tip and the sponge also.
Warning! The sponge has been pressed but if moisture reaches it will
swell
Connecting
• Only reconnect the soldering iron from the base if is turned off or
better if not connected to the wall socket.
• Place the soldering iron into the stand.
• Connect the soldering iron to the station.
• Make sure the wall socket is grounded.
• Connect the power cord to the grounded wall socket.
Warning! Make sure the soldering station is power off when you
connect the iron to it, otherwise it may cause damage in the device!
Operate and setting the temperature
• Turn on the device and set the requested temperature with the knob,
the LED is illuminating which means the station is heating up.
• Later the LED will off and after few seconds it will blink which is not
an error symptomsis normal. That means the station is try to keep
the selected temperature so “heat up and stop, and heat up again
and stop”.
