40i TS - v1205 - Installation/Operation - (29/29)
Maintenance
Cleaning:
An accumulation of dirt in the equipment can act as a screen preventing proper dissipation of the
heat generated by the internal electronic circuits with the consequent danger of overheating and
DRO fault.
Accumulated dirt can also, in some cases, provide a conductive path for electricity which could give
rise to faults in the internal circuits of the equipment, especially in high humidity conditions.
To clean the equipment nonabrasive dish-washing detergents are recommended (in liquid, never
powder form) or 75% isotropic alcohol with a clean cloth. DO NOT USE aggressive solvents,
(benzol, acetones, etc.) which could damage the materials the equipment is made with.
Do not use high pressure compressed air to clean the item as this could give rise to an accumulation
of charges which in turn lead to electrostatic discharges.
The plastics used in the front panel of the DRO stand up to: Grease and mineral oil, alkalis and
bleaches, dissolved detergents and alcohol.
Avoid the effect of solvents such as Chlorohydrocarbons, Benzol, Esters and Ethers because these
could damage the plastics with which the front of the equipment is made.
Preventive Inspection
If the DRO does not come on press the rear switch for starting, make sure it is properly connected
and being supplied with the proper mains voltage.
Fagor shall not be held responsible for any printing or transcribing errors in this manual and reserves
the right to make any modifications to the characteristics of their products without prior notice.
FAGOR AUTOMATION S. COOP.
Bª San Andrés Nº 19
Apdo de correos 144
20500 Arrasate/Mondragón
- Spain -
Web: www.fagorautomation.com
Email: [email protected]
Tel.: (34) 943 719200
Fax: (34) 943 791712
