9
ENGLISH
To find out which model your oven is (“a”, “b”,
“c”) compare its control panel with the control
panels shown in the illustrations.
1.1 Unpacking
. Remove all the protective
packaging elements.
1.2 Mains connection
. Always take into account
the data on the reference plate (1.2.1) and
the measurements of the cabinet in which
the oven will be housed (1.2.2, 1.2.3).
The appliance must be connected to the
mains with a fixed single-phase connection
with the neutral-to-neutral (blue)
connection guaranteed (1.2.4). Fit the oven
into the space and centre it (1.2.5). Make
sure there is no excess cable in the upper
part (1.2.6).
Screw it to the fitting using the two screws
supplied (1.2.7). The fitted unit or its surface
must be heat-resistant. The time must be
set in order to finish the installation (model
“c”).
when the countdown ends. Press any
button to stop the beep.
2.4
Before using your new oven for the first
time, heat it up while empty (with no food
in it and with the control turned to
, for
30 minutes at 250ºC). It may produce some
smoke or a bad smell (this is normal and
is caused by the oven heating up grease
residue etc.). When it has cooled down, pre-
clean it by wiping the inside with a damp
cloth.
2.5 Accessories
. Depending on the model there
is a Deep Tray (2.5.1), Standard Tray (2.5.2)
and Juice catcher Grill (2.5.3) that work
separately. It is also possible to combine
either tray with the Juice catcher Grill (2.5.4)
to make one unit. All the accessories or
units can be used directly or mounted on
the Partial Extraction Guide (2.5.5) or the
Total Extraction Guide (2.5.6, 2.5.7, 2.5.8,
2.5.9). If you have the partial extraction
tray, it can be used separately or together
with trays (3 types) (2.5.10). The Simple
Grill is used separately (2.5.11). If you have
telescopic rails, remove the tray before
installing them in the oven (2.5.12). The
telescopic rails extend automatically due
to the weight of the tray when the oven
is opened (2.5.13). Food must always be
placed on a tray on the telescopic rails
(2.5.14). Bear in mind the position of the
grills when inserting them. There are anti-
tipping stops at the sides (2.5.15).
2.6 Accessory positions
. The accessories can
be fitted in 5 different positions. According
to the model, the position on which to
place the tray will be shown on the display.
.
2.7 Cooking the food
. Place the food in the
oven. Choose the accessory or accessories
to be used and their recommended position,
or consult the cooking table. Close the oven
door
.
COOKING A DISH
2.8 Selecting the cooking function
. Turn the
function selector and select the desired
function according to the model (2.8)
.
Traditional fanned heat.
For any kind
of dish. Several dishes may be cooked
at once without their flavours or smells
mixing.
Turbo plus
. The heat is produced by the central
element. In absence of the defrost function it
is possible to use this function at 35ºC.
Fanned high grill
. This browns the food,
2.1 Setting the time
. Digital models
When you switch on the oven, the display
will flash (2.1.1). Set the time by pressing
(2.1.2). The hour will automatically
be validated after a few seconds.
Note: The time will need to be reset if a
power cut occurs.
2.2 Changing the time
.
With the oven turned
on, press
for several seconds with the
time flashing, adjust the time by pressing
(2.2.1) for several seconds. The
hour will automatically be validated.
2.3 Beeper function.
With the oven turned on
press
twice until the
position. Adjust
the time by pressing
(2.3.1).
After a few seconds the time will
automatically be validated and the
countdown will begin. A beep will sound
1.
INSTALLATION
2.
USE
0.
IDENTIFICATION
Summary of Contents for FOE114BA
