Fagor FDD24, Service Manual

Page: 15 / 29

BAR EQUIPAMENT OPERATIOS AND SERVICE MANUAL
Outside cabinet:
Be sure the unit has good air circulation around it. Avoid hot corners
and locations near stoves and ovens. It is recommended the unit be
installed no closer than 2” from any wall. The place where the
refrigerator is placed must be open and clean, avoiding that de fan of
the condensing unit absorbs materials which are deposited then into
the condenser blades and coil, which can produce failures.
3.6 DATA PLATE
The data plate in located inside the unit, near the top front left corner.
Under no circumstances should the data plate be removed from the
unit. The data plate is essential to identify the particular features of your
unit and is of great benefit to installers, operators and maintenance
personnel. It is recommended that, in the event the data plate is
removed, you copy down the essential information in this manual for
reference before installation.
3.7 ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual or on data plate and your
local code or the National Electrical Code to be sure unit is connected
to the proper power source. Verify correct incoming voltage according
to the Data Plate information.
HEAVY APPLIANCES
A protected circuit of the correct voltage and amperage must be run for
connection of the supply cord. Unit must be grounded and connected
in accordance with NEC Article 422 Appliances.
DANGER: Power must be turned off and
disconnected from the power source whenever
performing maintenance, repair or cleaning the
condensing unit.
If unit still running when power is off, disconnect
power at the circuit breaker before unplugging
the machine.
WARNING: Unit and compressor warranties are
void if failure is due to improper electrical
installation.